Taking bike measurements

On the capture screen you will see a button for “MEASURE BIKE”:

Capture panel
Capture panel

Clicking “MEASURE BIKE” will open the bike measurement popup window:

Bike measurement window
Bike measurement window

Follow the instructions on screen to use the wand to acquire the indicated points. Once you have acquired a point a red dot will appear on the image. If the dot is not aligned with the image you can click “Redo” to re-acquire.

Measurement points differ slightly between road, mountainbike and tri disciplines. The remaining measurement points for road discipline are listed below.

Bottom Bracket measurement point
Bottom Bracket measurement point
Seat post head measurement point
Seat post head measurement point
Tip of saddle measurement point
Tip of saddle measurement point
Centre of saddle measurement point (use your green saddle jig)
Centre of saddle measurement point (use your green saddle jig)
Frame x y - centre top of the head tube, under the spacers
Frame x y - centre top of the head tube, under the spacers
Curve of far hood measurement point
Curve of far hood measurement point
Top of handlebar measurement point
Top of handlebar measurement point
Bar end near drop measurement point
Bar end near drop measurement point

If the diameter of the bars is something other than 31.8mm use the drop down box at lower left to select a value. If the bar diameter isn’t in the list, choose “Custom” and manually type the bar diameter.

Setting bar diameter
Setting bar diameter

When all measurement points are captured, and the bar diameter is correct, click Next.

On step 2 you will see the bike measurements as well as free text fields to record bike details:

Measure step 2
Measure step 2

You can manually alter the bike measurements by clicking on the field. For instance - many road handlebars have flared drops so it is hard to get an accurate measurement when comparing tops and drops. In this case you could choose to measure across either the hoods or drops and enter the value into the HANDLE BAR WIDTH row.

For the setup details you can enter any value.

Once complete press Finish. Your bike measurements will be saved into the fit log, and the initial and final bike measurements will be included on the fit report.